邻苯二甲酰基保护氨基的脱保护

  • A+

     Pht-氨基衍生物很容易用肼处理脱去。一般用水合肼的醇溶液回流2 小时或用肼的水或醇溶液室温放置1-2 天都可完全脱去Pht保护基。在此条件下Cbz、Boc、甲酰基、Trt、Tos等均可不受影响。在肼效果差的情况下,NaBH4/i-PrOH-H2O(6:1)和AcOH在80℃反应5-8小时,这个方法是很有效的(见下式)。另外,浓HCl回流也容易脱去Pht保护基。


一、 NH2NH2/MeOH脱除邻苯二甲酰胺示例

W. Shijun; Y.Zhujun et al., Org. Lett., 2004, 16, 2721

To a solution of compound1 (313 mg, 1.04 mmol) in MeOH (6 mL) was added hydrazinemonohydrate (0.1 mL, 1.67 mmol) at 0 °C.After being stirred at same temperature for 3h, the solvents were removed invacuo and the residue was re-dissolved into water (10 mL). The pH ofsolution was then adjusted to 1-2 by adding 1N HCl at 0 °C.The whole mixture was stirred for 1 h at rt, and then filtered. The filtratewas treated with solid Na2CO3untilthe pH reached 9-10. The mixture was extracted with CH2Cl2(10 mL x 4). Thecombined extracts were dried (Na2SO4), concentrated and dried in vacuo toprovide compound 2 (209mg, quantitatively) as a yellowish oil.

 


二、NH2NH2/EtOH脱除邻苯二甲酰胺示例

Lee, Chang-Hee;Lee, Jin-Suk et al., J. Org. Chem., 2005, 6, 2067-2074

Compound 1 (1.66 g, 4.77 mmol) was dissolved in ethanol(50 mL), and then hydrazine monohydrate (0.93 mL, 19 mmol) was added. Theresulting mixture was heated at reflux for 24 h and then cooled to roomtemperature. The mixture then was combined with aqueous NaOH (50 mL) andextracted with CH2Cl2. The solvent was removed in vacuoto afford compound 2 (0.79 g,76%), which was used directly in the next step without further purification.

 

三、HCl脱除邻苯二甲酰胺示例

Lee, Chang-Hee;Lee, Jin-Suk et al., J. Org. Chem., 2005, 6, 2067-2074

Compound 1 (1.0 g, 3.86 mmol) and concentrated HCl (3 mL)was heated for 60 h at 100 °C.After the mixture was allowed to cool to room temperature, water (20 mL) wasadded. The solid precipitate that formed was removed by filtration anddiscarded, and the aqueous layer was washed with diethyl ether twice, withthese washings also being discarded. The water was removed in vacuo, and the remainingsolid was dried to give compound 2 (0.61 g,95%), which was then used to the next step without further purification due toits instability.

 

四、 NaBH4/i-PrOH-H2O(6:1)和AcOH脱除示例

J. O. Osby; M. G. Martin et al., Tetrahedron Lett., 1984,25, 2093-2096

To a stirred solution ofcompound 1 (0.36 g, 1mmol) in 2-propanol (7.7 ml) and H2O (1.3 ml) was added NaBH4(0.19 g, 5 mmol). After stirring24 h, TLC indicated complete consumption of starting material. AcOH (1 ml) wasadded carefully and when the foaming subsided, the flask was stoppered andheated to 80°C for2 h. The crude reaction mixture was then eluted onto a Dowex 50 (H+)column (2.7 x 10 cm),washed with H2O (150 ml), then eluted with 1 M NH4OH (200 ml). Ninhydrin-active fractions werecollected and pooled for freeze drying, and thus afforded compound 2 (0.2 g, 89%) as an ammonium salt.


本文非原创内容,版权归原作者所有

weinxin
我的微信
关注我了解更多内容

发表评论

目前评论:0